MAINTENANCE OF RAISED FLOOR PVC COATED PANELS

FIRST CLEANING

The dust of the panels should be removed with natural cleaners such as arabic soap and a damp cloth. 15 minutes from the first cleaning. Then the same process should be repeated and the surface should be dried with a dry cloth. Polish or nourishing cream that may be needed by the surface should be applied 2 hours after these procedures. Although there is no requirement (except for plastic laminate surfaces), it is recommended that nourishing varnishes be applied to the surface manually. However, the polish should not contain solvent and perfume. Wet cleaning methods are minimized. Dry and moist mopping is usually used instead.

DAILY CLEANING METHODS

1. Vacuum Cleaning

Vacuum cleaners and vacuum cleaners are enough to remove daily dust and dirt from the floor

is a method. If the surface is to be polished, brooms with polishing feature can also be used. As long as there is no stain on the surface, heavy hand polishing is not required.

It can be applied instead of matting for hard-to-reach places. It can be applied for pre-cleaning of coarse dust and dirt.

2. Dry Mopping

Choose a dry or slightly moist rope mop, microfiber mop or disposable mop. In addition, a mop dipped in a dust-holding liquid can be used. It should be done daily.

3.Moist Mopping

Moisten the mop with water or a diluted cleaner solution, squeeze or moisten it with a sprayer.

Make sure that there is no water left on the floor. Within 15-20 seconds, the floor should appear dry.

It should be done daily. Liquid polishers can be used for daily cleaning. Natural detergent can be added to the cleaning water while mopping damp.

4. Spray Cleaning

Used for light dirt. Mix water and neutral detergent in the container. The proper speed is about 1,000 rpm.

It is suitable for regional cleaning.

Stain cleaning and brushing are done in the same process.

5.Stain Removal

If it does not remove stains with cleaning;

Shop for a white / red nylon pad with neutral detergent. Then wipe it with clean water.

For superficial stains, polishing with dry cloths with fiber or wool properties will be sufficient.

In case of damages or deep cuts caused by smoking and flammable support, the panels should be re-coated or it will be required to register with the company.